Home > Products > Appearance

Appearance

 

See also :: Decking :: Outdoor :: Structural

 

Schulz & Mathiasen produces a range of appearance grade products from pruned logs, with the objective of maximizing Clear Grade recovery. Our appearance products are visually graded by qualified graders, and externally audited to ensure accurate and consistent grades. These appearance grades are available in various conditions including rough sawn, planed or profiled, treated and as cut to length components.

No. 1 Clears

Clear on both faces and both edges, may contain occasional small blemishes. Suitable for moldings, furniture, boards, cladding and decking where clear, long lengths are required.

No. 2 Clears

Clear on one face and one edge. The second edge may contain a characteristic no more than 1/3 of the thickness. Suitable for usage where one clear face, two clear edges are required.

Dressing Grade

May contain up to three major defects no more than 30mm in diameter on the Dressing Grade face. Defect combinations on the back face up to 0.5 the width of the board. Used for furniture, boards, paneling, and high quality exterior use.

No. 1 Cuttings Grade

Each piece shall yield one 1.8 metre clear cutting, with balance of cuttings averaging 1.0 metre. Minimum of 70% recovery of clear cuttings.


No. 2 Cuttings Grade

Each piece shall yield 70% of its length in clear cuttings 0.600 metres and over.

No. 3 Cuttings Grade

Each piece shall yield 60% of its length in clear cuttings of 0.200 metres and over.

Merch Grade

A general utility grade allowing knots up to 0.5 the width of the board, and may contain pith. Economically used for workshop and warehouse shelving, framing for upholstery furniture and fence palings.

Packaging-Industrial Grade

Suitable for packaging, pallets and other industrial use.

                                                                                                                            

Please note: Real product may vary slightly in presentation

Sizes Available

  • Thicknesses: 25 mm, 32 mm, 38-40 mm, 50 mm, 75 mm, 100 mm
  • Widths: 50 mm, 75 mm, 100 mm, 125 mm, 150 mm, 200 mm, 250 mm, 300 mm
  • Lengths: 1.8 metres to 4.8 metres. Other lengths by special request.

General Information

  • Timber is shown machined to clarify appearance. Can also be supplied sawn.
  • Schulz & Mathiasen will produce grades and sizes to customer requests and customize standard grades to meet specific needs.
  • Target moisture: 10-12%. Range: 8-14%.

Please contact us at info@smlumber.dk for prices.

Home > Products > Appearance
Contact Information
49 Howitzvej St, 2000 Frederiksberg, Denmark
 
info@hmathiasen.com
info@smlumber.dk
Copyright © 2018 H.Mathiasen Holding ApS. All rights reserved.